1- Tips for using wall post in metal frame
One of the easiest ways to implement coercion is to use it in a metal frame. In order to implement the metal frame post wall, the connection of the post wall to the column and beam must be done from the beginning by welding. The use of this force is in buildings that must be made of a metal frame.
In order to force the metal skeleton to be fully implemented and in the best condition, several points should be mentioned:
☑️ The correct angular drawing horizontally during forced execution ☑️ Not using rebar instead of corner for horizontal coils ☑️ Putting the corners back to back so that the wall is inside it from one side.
2- Tips for using wall post in concrete frame
How to implement the wall post in the concrete frame is different according to the forced type. In general, both types of metal and concrete reinforcement can be used in concrete frame structures. The most important points to pay attention to in these methods are as follows:
🔰 Implementation of concrete post wall in concrete frame
In implementing the wall post in the concrete building, first the exact location of the wall post should be determined according to the plan. When constructing the wall, the distance between the wall posts should be left empty.
For implementation, connection sheets are installed on the beams and roof, and after the construction of the wall, four rebars are welded to the sheets. Next, we tie the rebars to the fasteners between the wall blocks using reinforcing wire. In the next step, both sides of the frame wall are closed and concrete is poured into the frames. Finally, after opening the frames, we will have a concrete post wall with a thickness matching the thickness of the wall.
🔰 Implementation of metal post wall in concrete frame
Before concreting, the base plate should be executed under and on the concrete beam. If this is not done, the connection of the blade or column should be done by running the wall post with anchor bolts or roll bolts. To avoid any problems, accurate measurements should be taken before welding the forceps. Stringing is necessary to control the horizontal alignment of the forces.